Bambu Lab P1P Shorter Spool Holder (Remix)

UPDATE - 01/28/2023
Replaced the Body and Cap stl files with version 2.  The original cap easily pops off during use.  I re-designed the cap to snap on, but it is NOT meant to be taken off and on many times because the thin wall on the body may snap off.
 

01/08/2023
I felt like the original was a little too long.  When the spool of filament was at the end of the spool holder, I could see the spool holder flex.  I wanted a shorter version of the BambuLabs X1/X1C Improved Rear Spool Holder for a few reasons.  

1. I really only use 2 brands of filament, and the spools are no wider than 68 mm.
2. Save on the amount of filament used.
3. Use 1 less bearing.
4. Stop the Cap from spinning or falling off during use.

The length of the spool holder went from 112mm to 82mm.

I am using this spool holder along with my Bambu Lab P1P Spool Arm, and connecting it with (2) M3x25mm Socket Head Cap Screws and (2) M3 nuts.  You can still use the same 608-2RS bearings.  To assemble the spool holder, you will need 3 bearings and 2 spacers.