May 20, 2023
Description
Print in 0.2mm layer height. Be sure to have thin wall detection on!
The picture is printed on a 1.4mm thick plate. Plan your color change after that z-height. I colored the eyes by adding color in the back plate using Bambu Studio.
Because the big chance of warping the picture has a brim firmly attached. Use an exacto-knive to remove it afterwards.
The frame has a 2mm overlap, so small damages caused by removing the brim will not show in the endresult.
Printing the frame might also require a brim. Use your slicer to add it.
The picture clicks in the frame at the back.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
Magnatic Design
