Case for LD2410 radar module and D1 Mini

Case to hold a LD2410 MMWAVE sensor module and a Wemos D1 mini board.

The radar module can be rotated horizontally to adjust the angle and direction it is sensing.

Four parts:

1. The case that holds everything
2. A holder for the radar module.
3. Snap-fit lid to cover the case
4. Snap-fit lid to cover the case with a logo (optional)

The radar module is held to the pivoting holder by a JST connector that is inserted from the back. This should hold it firmly.

The clip is used to secure the angle of the radar module and to hold the D1 in place.

There is a little notch in the case where you can insert the small side of the clip. The other end has to be secured with a small screw. (2,5-3mm).

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

0,20

Infill:

Notes:

To print the cover with the logo in two colors as on the photo change the filament to a different color at layer 10 (2mm)

Category: Electronics