Card Hand Holder

I used Polycam, Blender, and Fusion 360 to create this low-poly card holder. It’s a re-sculpt of my Hand Holder. Pardon the pictures. I’m still tuning the filament.

Print with supports:

Use the 3mf file in Prusaslicer or the gcode for my setup.

Consider following @Misha.in's make of the first hand design I made:

…First, I printed out the attached gcode, but I found a few flaws in it. Mainly it was very light and fragile. Therefore, I doubled the number of perimeters to 4 and poured sand into the model during printing. Now the hand is steady as a rock.