Smart Watch Holder Krostming 4G Kids Watch

A holder for a Krostming 4G Kids Smart Watch for charging. 

It includes a small cavity that can hold the charger plug which is magnetic and will also hold the watch in place. The cable is not fully hidden and run down to the bottom like in other models, because the original cable is too short for that.

I printed it in an upright position like this:

With that it was possible to print without any support structure. I had to use a raft to assure proper build plate adhesion until the two parts are connected at the top.

Note that Cura complained about the stl model not being watertight, and it may have small errors, but I could slice it without any problem.