OctopusCase (or any other electronics)

This is designed to be easily remixable case for holding electronics. With this configuration it takes BTT Octopus board and 60mm fan. The cable collar is from RatRigs Electronics Case and is designed by them and shared under Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International. Pylons have a sacrificial layer for the top hole so make sure to print it in correct orientation. It should be the right way up to begin with.

Hardware for this configuration:

• 60mm fan with mounting screws (the holes are sized for noctuas mounting screws)
• 8x m3x10 for the lid and board mounting (lid ones can be longer if you drill a bit further on the corner pylons)
• 4x m3x16 to for floor and feets
• 8x m3 nuts (not locking!)
• 4x m3x12 for fan panel
• 12x m3x10 or m3x12 if you wanna be safe
• 16x m3 locking nuts
• 8x m3 heat inserts for feet and for board mounting

I am sorry if I forgot something. Feel free to remix and share your own panels for different needs and with different designs!