All these designs are tinkercad specials. Nothing super fancy, but quite functional. Big Shout out to oliver c for his original design.
Sabre_nose_dji_O3.stl:
Nose that fits the DJI O3 Air Unit Camera
Large scoop up top, and 2 on the sides of the camera to cool the vtx
Sabre_nose_dji_OG.stl:
Nose that fits the original DJI Air Unit/Vista camera
Large scoop up top, and 2 on the sides of the camera to cool the vtx
vista mount sabre.stl:
Front sled for the sabre with 20x20 mounting. I printed in petg and sunk m2 brass fittings into the holes with a hot soldering iron around 230C. then just screw the vista in from the top. using some gummies underneath is recommended so airflow can get under the vista.
Glue in with ca glue to the front rails
FC mount matek sabre.stl:
Rear sled for the sabre with mounting for a matek f405-wmn, and also the daughter breakout board for the buzzer and usb, to be mounted on an angle so usb access is easy. Also has mounting for a matek m8q-5883. I put vhb under each item and stuck them on. The main flight controller also got m2 screws. Glue this to the rear
Glue in with ca glue to the rear rails. Escs can mount under the sled for a clean look, but BE CAREFUL of the screw heads if you have the fc screwed in.
sabre mount.stl:
Wall mount for the sabre. Stick to wall with 3m command strips.
mouseFPV
