Unifi AP Removal tool

I was liking the layout of thing:3661633, but needed thing:1284641.

I did not feel comfortable printing thing:1284641 out standing up, or even on its side with supports.

Since I wanted the most strength, I decided to mix them, in a way. Basically a thin flat printed part, that is heated and twisted to work similarly to thing:1284641.

It is still a little flimsy, but it works. And it took 11 minutes to print up 4 on my prusa mini.

After printing, use a lighter or other heat source. Heat the entirety of the straight part of the plastic quickly until it gets to be malleable. Slowly twist the entire length of the tool until it is 1/4 to 1/2 twisted. Make sure the twist is gradual. Let cool.

Print instructions

Category: Hand Tools
Printer Brand: Prusa

Printer: Mini

Rafts: No

Supports: No

Resolution: 0.20

Infill: Does not matter

Filament: MakerGeeks PLA Translucent Green