remote control bucket for ivar shelf

This is a bucket for a remote control. The bottom of the bucket has honeycomb holes to let the dust through.
It is meant to mount on the sides of an IKEA ivar shelf. It can mounted just by the stud into a normal mounting hole. I added a hole for a wood screw to secure it.

You can choose between 2 designs and left/right mounting position.

If it is to hard to clip the stud into the hole, the sand it down a bit until it fits for you. I use a wood screw to make it tight. Please do not over tighten the screw to avoid damage on the plastics.

print instructions

• 10% cubic infill
• in height of 25mm to  33mm use ~40% infill to make the screw through hole more rigid

additional notes

I'm interested in your feedback to improve my stuff! So give me likes, post makes, comment and rate the print to show others and me how well it goes.
If you post a make, let me know which filament you use.

If you want to support me by donating a coffee go to https://ko-fi.com/antimaterie I would really happy about it. The money will be invested in all stuff regarding 3d printing to give more and better quality models.

In general my Prints are not for commercial use, but if you are a print farm owner and want to sell some of my stuff, please contact me.

Hope you enjoy my models.