January 28, 2023
Description
From Thingiverse:
Couldn't find any plug and play ADXL345 holder, so i designed my own. It's designed to be used in place of the stock probe, so the only additional thing you need (obviously other than the adxl345 itself) it's a neodymium magnt 20x10, which can be temporarily unscrewed from the probe, and a couple of screw. However, i suggest to buy a second magnet to avoid wear on the probe screw hole.
This design comes in 2 variants:
The Adafruit one has been realized using the official datasheet, so dimensions should be fine, but again, i can't assure.
if you have the GY-291 generic module, you will need standard m3 screws, if you have the Adafruit one, I'm not sure, but i suppose you will need M2.5 ones.
The mount has been tested with great results on Klipper's resonance test.
License:
Creative Commons — Attribution
7
vilerage
