Heat Set Insert Press For Threaded Inserts.

I made this for an upcoming Voron project. It's based upon parts I already had lying around.

Since I don't had a suitable spring I used a piece of silver "Thera Band ®". But you can use any other elastic band, that is strong enough instead.

The "Iron-Clamp" fits my Ersa Multitip 25 soldering iron with a diameter of approximately 23 mm. I made the clamp changeable, so if I ever want to use a different soldering iron, I won't have to print the whole "boom" again

Because of the heat, that comes frome the soldering iron, print with heat resistant Filament!

Use at your own risk. Soldering Irons are getting very hot and can cause fire!

Additional parts needed:

25mm Aluminum Tube approx. 450mm long

10mm Aluminum Tube approx. 130mm Long

Piece of plywood.

Piece of Velcro tape

Piece of elastic band e.g. silver "Thera Band ®"

M4 and M3 screws and washers.

M4 Threaded inserts.

Print Settings

Rafts:

No

Supports:

Filament: Your Choice Heat resistant Filament

Category: Tools