An OpenSCAD model for wet area caddies. Lifts bottles and soap off the bench top surface to allow the water to dry. Helps prevent staining of the bench.
Configuration options arei:
- Section: For when adding the drip tray option see below.
- Width: Cubby Width (mm)
- Depth: Cubby Depth (mm)
- Beams
- Beams Spacing: Spacing of beams (mm)
- Beams Count: Number of beams, overrides spacing
- Height: Height of main beams (mm). Does NOT include feet, lips, or tails
- Thickness: Thickness of beams (mm)
- Cross Beams
- CrossbeamHeight: Height of cross beams (mm). Default if 0, Beam Height *3/4
- CrossbeamThickness: Thickness of all parts (mm). Default if 0, Beam Thickness
- CrossbeamPositions: Cross Beam position on beams, 0 start 1 end.
- Drip Tray
- TrayThickness: thickness of drip tray
- TrayAngle: Angle of drip try (Will need to adjust based on depth
- Feet
- Feet: Do you want feet on the bottom?
- Feet Interval: Interval of feet on beams, feet are always on first and last beam?
- FeetSize: feet diameter default if 0 is height (mm)
- FeetThickness: feet thickness, default if 0 is Beam Thickness (mm)
- FeetPosition: Feet position on beams, 0 start 1 end.
- Tail: Do you want a tail sticking up on the rear?
- Lip: Do you want a lip sticking up on the front?
Drip-Tray
You can include an angled drip-tray to direct the water. This is intended to prevent most of the water from hitting the shelf bellow. The tray makes it hard to print without supports so it is split in to two parts. The bottom has the angled tray, the top will sit on the bottom to give a flat top for the soap or bottles.
Printing:
Nothing special to consider. Print top down to prevent the need for supports
This is a remix of the model created by Kroyster. Thanks to him for his work on the original script. https://www.thingiverse.com/thing:2739020
Max
