Self-watering plant pot

It's a two part flower pot with a lifted bottom acting as a water holder. Pot for the plant has a 4 holes so the rope will have contact with the water witch goes up the rope and to the roots. Outer shell is elongated on the one side so there is a place to add water to the reservoir without lifting the plant pot.

Print instructions

Print is separated in two parts, inner and outer shell. Both of them need supports at the bottom but only for couple of layers i could make the version with 45˙ so there is no supports but I liked the aesthetic of this lower angle one better. In my case reservoir holds the water well of the printer, no need for additional water insulation, I had the flow rate at 98% as a normally do for all prints.