8mm x 2mm Magnet DeWalt Bit Holder

Great model by ucancallmebob89 on Thingiverse: https://www.thingiverse.com/thing:4419204

I only had 8mm x 2 mm round rare earth magnets, so with a bit of TinkerCAD time I was able come up with a mod to fit my needs.  The use of built in supports where needed is quit a slick trick, good thinking Bob! 

I went ahead and tried the magnets attached through the bottom so that I could easily enlarge the magnet holes if needed. The magnet holes are printed to exact size and after a very brief widening of the beginning lip with an over sized drill bit, the magnets slid in beautifully. Little bit of super glue and they ain't goin nowhere ;) 

I never realized how often I could use an extra hand to hold a few screws until I installed this model!

This print fit my DCF787 Type 1 ¼" Impact Driver

Thanks again for the effort ucancalmebob89!