Trailer for the FPV-Rover

This is a remix of the OpenRC Truggy designed by Steamerzone.
http://www.thingiverse.com/thing:378042
The tires are a remix of the small tire by Bastien.
http://www.thingiverse.com/thing:626863

It is designed for the FPV-Rover (V1.0)

And for the FPV-Rover (V2.0)

Print instructions

Print everything with 15%-25% infill. Support not needed.

Use PET, Flexifil, Ninjaflex... for the tires.

Due to the limitation of my printbed I had to cut some pieces into more parts. If your printbed is big enough, print the complete parts (like, frame front, frame rear, fender, ramp, front).

Parts to print
1x fender
1x front
1x center
1x frame hitch
1x frame front
1x frame rear
1x hinge
2x side
4x tire
4x rim

Parts you need:
2x M5 threaded bar (23cm-24cm)
8x M5 nuts (for each wheel two to center the wheel on the threaded bar)
1x 6mm metal pipe with 5mm hole
1x M3 threaded bar (7cm-8cm)
1x M3 nut
2x M3 washer
1x spring from a pen
M3 16mm screws
M3 10mm screws