Prop Box for 2030 4 Blade Propellers

Tired of having your propellers fly around in your bag and then when you break one, you just can't find one with the right direction?

This convenient propeller carrying case solves that issue! It is designed specifically for Racerstar 2035 propellers and fits 6 pieces. They are held in place well in two stacks (three of each direction) so that it is easy to pick the right one.

The lid has a snap fit so that it does not fall off in the bag. Just press the base slightly where the snap fits are and the lid comes of easily.

I use these for my Blade Torrent 110 and they are just perfect!

Where to buy the props: 10 Pairs Racerstar 2035 (Affiliate link) 10 Pairs Racerstar 2035 (Non-Affiliate link)

Print Settings

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2mm layer height

Infill:

Notes:

You will need to rotate the lid to make it lie on it's back.

As there is not much infill the infill percentage will not impact the print speed significantly. You will need some as the top and bottom plates are 2mm thick leaving a tiny bit of air in the middle (unless you go for 5 top/bottom layers, however that is not necessary).

Category: Hobby