Mario Pipe Pen Holder (Easy Print)

This is a remix of Andre Stadler's Mario Pipe Pen Holder. I cut off just the bottom of the base of the green pipe section to allow for a support free print of the pipe when printed top-side down.

This does mean that if you ever lift the pipe from the block, you're gonna have a bad time, but that can be solved by either gluing the parts together, or just not doing that.

I found that when printing on my AnkerMake M5, whether it was the filament I used or just the model, I had to slow the pipe print speed down to 3x (150mm/s), but the base prints fine at 5x (250mm/s).

Images shown printed in Overture Green & Overture Brown PLA, base was also coloured using a black sharpie in between bricks, although this bled quite a lot so maybe not the best idea.