February 8, 2023
Description
Modular Tealight Covers in Love Theme
You can make 3 completely different Cubes out of this set
9 decorative side panels
3 side panels with text (+3 with flipped text)
4 base panels
3 top panels
Models from this pack are shown on first render
Flipped panels are with a text to be projected on walls (like 'Love' on photos)
---
Language packs
With text panels in different languages
Every pack is with 2 completly new side panels and 1 top and base panels
All the models with names and language pack name are on the last two renders - original pack marked with green line
---
Short video with rotating cubes:
https://www.instagram.com/p/CnZRIbUKeYS/
Video with overview, assembling process and 360*:
https://www.youtube.com/watch?v=j54gx06BeZI
More photos:
https://www.instagram.com/p/Cnoc3i1Noqd/
---
I tested it with small tealight and everything was fine but I can't be sure if this Cubes can survive bigger flame tealights
Test one first for at least 30min or just use LED candles like I did (on photos, without a cover for more light)
If after assembling you will want to change panels or just rearrange it - take your time. Don't pull whole panel too hard, just do it partially one joint at a time. Some panels are more brittle than others and you can break it if you will not be carefull
There should be no problems with assembling tho
Models made in Blender 3D
Printed on Voron 0.1
---
This models are free only for personal use
I can make exceptions to prints sold on charity auctions - you just need to notify me about this and put a link to files in auction descripton
This apply to most of my models so feel free to write to me
---
0.4mm nozzle
0.2mm layer height
IMPORTANT
Prints needs to be clean so you will need to proper set the slicer and printer or clean the print after
Flow, XYZ dimensions, retraction - this are the main problem makers that may make assembling difficult or even impossible without a knife or sandpaper
Print test file first
If it is too hard to assemble it (or it's bending after) or it's too loose you will need to change something (maybe just a flow a little)
It may change even with a different filament (I used 4, 3 worse quality needed just a change to 99%flow)
If panels are not holding each other but the prints looks nice and you don't want to waste more filament you can glue it together
Just don't use cyanoacrylate glue on PLA as it may leave white marks on it
License:
Creative Commons — Attribution — Noncommercial — NoDerivatives
C47_3d
