Love in Two Colors

Though Love in Two Colors design is optimized for printing is two colors, it will print fine as a one color model. That being said, I encourage users to try to print it in two colors. Easier than you think. If you have a single color printer that has the ability to pause and change filament mid-print then you can easily make this print.

Do your own research on how to pause and change filament mid-print. Once you’re ready to try it, you just need to pause your machine when it completes 12mm of printing and switch to a second color to complete the remaining 6mm.

If you have a Prusa with an MMU2 unit, you don’t need a layered 3D model. Research how to use the advanced settings layer controls to enable a color switch at the 12mm level.

Another method included with the models of the top and bottom layers. Print each layer out in a different color. Add a little CA glue near, but not over on the bottom edges of the top layer, center the top color over the bottom color, hold in position and place a book or two on top to keep pressure on the assembly for a while and you’re done.

Models in three sizes included.