Resin Print Dryer

This is a design I made for quickly drying the IPA off of resin prints after they have been washed. As many of you know, if you leave IPA on the print while it cures in UV light it can ruin the finish. Normally I just let it dry in the air for a few hours then cure it but with this fan i can put it in the curing machine in mere minutes.

Print the parts, use fan shroud to trace a cutout on the mesh with pencil. Use scissors to cut the mesh out. Super glue everything together.

I used a Mesh bought off Amazon but BloodSteyn made this remix which doesn't require the mesh. It was a good idea that I did not consider in the original design. That is what I love about the community, we can all build off of each other and make better stuff :D

This is the fan used from Amazon:

https://a.co/d/cyianGy

Here is the mesh used from Amazon:

https://a.co/d/2yDVG6Q