Sofirn SP10Pro Diffuser Cap (vase mode)

Just a simple, easy, fast printing light diffuser for the SP10Pro.  Friction fit on the head as per my light.  Easy to scale up/down a little for clearances. 

I've included 2 files, one straight off the diameter of the light plus 1.6mm for both (0.8mm)walls,  and one that adds the 0.25mm(inclusive) that my printer is off in x/y.   Print just the bottom 10mm of either and you can get a fast easy test fit for scaling up/down.  

Added an extension on the end with a tube for a lanyard. In my slice(Cura 4.8) it Almost closes the inner top of the tube, and only glitches a few strings over one hole, its easy to clean up after. 

Round bumps were to stiffen the walls while printed single layer( but at 0.8 it hardly needs it. )

Modeled and designed to run in vase mode/spiralized outer contour at 0.8mm walls(Runs from a 0.4mm nozzle just fine for me).  I sliced at 0.3mm layers, and printed in Sunlu white PETG, but anything fairly translucent should be fine. 

As I have time I might add other files set for different wall thicknesses, interested, let me know?