Amewi K120 swashplate

It replaces the upper part of the Swash plate, which is usually one of the first casualty during a firm contact with some sort of obstacle.

Printing:

The support material is allready fitted to the modell. just print it solid with 0.10-0.15mm layer hight. 

If the ball joints wont fit just right on the push rods because they are a little to big or to smal, do some adjustment to your extrusion multiplier. If you finally got to the point they will just barely fit, use some fine sandpaper to smooth the surface a little with some light brushes.

After installation, you have to melt down the little pegs on the ball joints to a  little plate. use a hot screw head or soldering iron. This will make the rods stay on the ball joints

My one is out of PLA and lasts allready for more than 50 charges. ABS and PETG might work as well.