Whoops! Backspace Eraser Keycap

Printing Notes:

1. I reduced the perimeters from 3 to 2 to make the text look better.
2. Printed at 0.10mm height.
3. Filament used: Overture Matte Pink PLA

Post print additional work:

I filled in the lettering with the some nail polish. Make sure the letters are totally covered. It's okay to go outside the lines. 

Once it's dried sand the top down until it's smooth and the nail polish is only left inside the letters. Also helps to create the looks of an eraser by rounding the corners a bit with some sand paper.

Then I sprayed a matte clear coat over it to seal it.