Ender 5+ Y endstop mod

Due to the bracing I chose to use while converting my Ender 5+ the stock Y endstop  wouldnt work and neither would the one designed by the ZeroG team so I made this to move the stock switch farther back, over, up and clearenced for the linear rail. 

This actuates off the same stop as the X endstop, can't seem to find the original designer for it but I didn't modify that, and allows the nozzle to home beyond the edge of the bed so you will have full use of the bed, confirmed only on the stock size, 377x370 with Stealthburner and TAP on single MGN12 rail, 410x410 is supported by the Hydra conversion but I can't confirm if this will allow full use of that bed.

Fusion360 file included if you want to make adjustments or modify to your use case. The screw holes for the switch are designed to accept a standard voron spec heatset and longer than stock screws. If you want to just thread into the plastic you may want to tighten up the screw holes a tiny bit. You can reuse the original screw used to secure the endstop to the frame. the wires will need to be plugged in before installation.