SDHC/MicroSD card case holder with flanges

This is a wall/rack mountable holder for the plastic cases SDHC/MicroSD cards come in. It's designed to be screwed into the wall or onto the face of a 1RU rack panel. You could also foam tape it to whatever you want. It's angled upwards to keep the cards from falling out easily, and the inside is tiered so that cards at the top stick out further than cards at the bottom. This makes it easier to remove the cards.

I have another similar design ("SD Card Holder with mounting flanges") for SDHC cards without cases.

Prints easily with pretty much anything. I'm using cheap PLA and it works fine with no supports when oriented in the obvious direction (flange side down). The base of it is a big ol' plastic rectangle so you'll have the usual gotta-pry-it-off-the-bed issues you get with any piece with a wide base. You could use a raft if that's an issue for ya.