Ender 2 Pro / Ender 3 - 5015 Part Cooling Fan Duct with Magnetic Mount

Ender 2 Pro / Ender 3 - 5015 part cooling fan duct with easy to install magnetic mount. Compatible with separate CR touch mount. Minimalist, compact and flexible design. This design has considered easy remix of your own mount for other printers.

Note: 5015 blower fan - set to 75% power for adequate and quiet part cooling

Compatibility

• Ender 2 Pro
• Ender 3 Pro / V2
• Ender 3 Neo / V2 (same as Ender 2 Pro mount? - not tested)

Printing requirements

• PETG preferred
• Standard supports for best quality

Other required parts/material

• 8x magnets 6mm (diameter) x 3mm (thickness)
• a few dabs of super glue to secure the magnets
• 4x M3 screws for 4010 hotend fan
• 1x M3 screw for 5015 part cooling fan
• 1x M3 hex nut for 5015 part cooling fan

Installation - Mount

1. Install magnets on to mount (4x) and shroud (4x). Make sure the polarities of the mount attract the shroud (i.e. N-S poles)
2. Unmount the original hotend and slot the mount through the hotend standoffs.
3. Reinstall the hotend