Winnebago Draw Catch

Winnebago Drawer Catch

This file creates the fixed half of the draw catch that's used in my Winnebago RV. This part attaches to the bottom of the top rail for each of the draws on the kitchen cabinet. 

It should be printed in the orientation as shown on the .stl file for maximum strength. 

I used Nylon filament for maximum strength. Other filaments could be used, but with the success I had with Nylon, I didn't pursue other options. 

I printed these with the following parameters :

• 3 top and bottom layers
• 5 perimeters
• 90% infill - gyroid infill pattern.

I have replaced three of the originals already, and they seem to be holding up just fine. Apparently, they're probably as good as those originally used. If not it's easy enough to print out more of them if needed and a lot cheaper as well!