February 22, 2023
Description
I design a new T-Slot bracket and Pi Camera stand for any printer with T-Slot 40x40.
Height is about 10cm, enough to peek at the extruder hot end.
Camera stand washer - contains T-slot 40x40 bracket with extra washer for different screw lengths
Camera stand - contains 1 vertical bracket to mount Pi camera holder(https://www.thingiverse.com/thing:4880054) and T-slot.
The printed screw holes are tight fit. Thus do use a drill bit to enlarge slightly to avoid breaking the screw mounting holes.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
10
Filament: Any PLA Brand PLA White
Notes:
Print without BRIM or Raft.
Removal of Support
You will need to remove the support for the camera bracket holes. Others support I just leave it there as not affecting functionality.
Location of the Pi Camera mount. Not the Face shield to prevent from light glare- Just a white piece of cardboard. You can print but should be quick and easy.
The CSI ribbon cable is short but did the job.
Actual View from the Pi camera in OctoPrint. You will need to refocus the Pi Camera lens by twisting counterclockwise as to focus for near object.
Category: 3D PrintingLicense:
Creative Commons — Attribution
9
yong3dprint
