Gerber Suspension Slide Holder - Molle Mount

This remix replaces the original belt loops with "locking" Molle clips. Several changes have been made to the clip and case design to print more easily without supports. I've also included a version with a small snap-out support I created manually but haven't tested.

A few of the back corners have also been rounded off. This normally isn't needed, but I wear this on the front of a backpack shoulder strap, and any edge ends up scraping me when I'm hiking and moving around.

Print upright and side-on so the Molle clips don't flop back and forth as it prints. (sideways is much better supported) I tested with PETG on several camping/hiking trips.