Holder for Can Opener (Rosenstein & Sons)

Now our can opener (Rosenstein & Söhne) has a separate place in the kitchen drawer. This leads to more space for pans etc. Can be taken off quickly, can be relocated on the rear folded sheet plate.

Designed with TinkerCad.

Printed on my Voron 2.4 (350). PLA. 

Edit: 04-Mar-2023:

Version V2 turned out to be located quite low, thus interfering with an easy despoit of the big (and heavy) pan.

Version V3 is extended and 50 higher resp. 100mm higher than V2. Therefore, I needed to make two retainers, so the whole construct does not fall backward, becaus of this higher centree of gravity. And for better printing I made four parts, which fitted very good. 3 self-tapping screws (Ø1.8-2.0mm) and 2x2 screws for the rertainers. Holes are already printed in. 

Note: The 50mm version I printed easy without support, the 100mm version I put some support in the middle for supporting the bridge(s). As said, version 50mm all parts without support.