Snap-Off Knife 18mm

Printing

Only the Bottom and Top parts need supports to be successfully printed, other parts are printable without supports. 

Assembly

The Front and Bottom parts must be glued together like the Top and Rear parts.

Be careful while assembling the 18mm blade into the body.

Step 1

Insert the Carriage through the Top part with glued Rear part and from the bottom side insert the blade a secure it in place with a pin on the carriage.

Be careful during assembling the 18mm blade with a carriage into the body.

Step 2

Roll the Wheel part onto the Bottom part. Only a few revolutions.

Step 3

Move the blate a little bit forward and insert it through the slit in the Front part.

Step 4

Align the hole in the Top part with the Wheel at the Bottom part.

Step 5

Secure the blade by tightening the wheel.