Pharmacy Printer Plate

Uniweb Style Scanning Gun Plate

Does your employer give you the bare minimum of counter space?

Do you have Uniweb style panelling?

Do you want to lift these chonky boyz out of the way and get a clean tear each time because the leverage forces the labels to rip off correctly?

Then this is the model for you.

Works With:

Zebra GK series printers with the same bottom mounting screws, initially spec'ed off of this model, but they use the same plate for 3 or 4 models all with the same shells.

Filament:

PLA-CF or stronger, this bad boy has a lot of weight pulling on it and it has to be stressed along the right points.

Printed on:

Ender 3 S1 

PEI Bed

Polymaker PLA-CF

Requires:

Four #4(2.84mm) sheet metal screws since the originals they replace are just barely long enough to fit the original casing, the plate adds enough to where the extension is completely necessary. 

If the screws are tightened down without removing the rubber feet the plate will crack.

Print on its side with tree supports or else you are looking at the plate snapping before the day is through.