Battery latch for WBT-1 electric scissors

Print

Print it on side, add supports for all overhangs of 20° or less (see PrusaSlicer) but remove supports from the inside of the leg (use paint-on supports' blocker). It would be hard to remove it after print and it's not needed. Use PETG or similar elastic material.

Installation

1. remove 2 screws from the battery pack
2. remove spring
3. remove cell pack
4. Red latches are from 2 pieces. Put screwdriver under the outside part and push it out. Smaller part inside will detach and you can remove both parts.
5. press printed part into slots
6. install cell pack
7. insert spring and close the case
8. put 2 screws while holding the case together