IEM Headphone Cable Clip Clamp Thingies - Cable Splitter Clamps for differnt IEM cables

I tried a cable clip (see remix linked) but that was too thin for my Moondrop Aria standard para-cord IEM headphone cable (8.4mm inside diameter, 6mm cable hole).  I liked the original clip so decided I to quickly recreate my own variation of it - my version uses the barrel / round splitter part of headphone cable to secure in place - simple snug fit with minimal cable stress. 

Also modded clip part to have a bit more surface area and bite. 

UPDATE #1: added a second version for the standard Salnotes 7hz Zero cable which might work with other cables - 6.7mm inside diameter, 5.2mm cable hole

UPDATE#2 05/10/2023: new version added for Tripowin Zonie 16 Core Silver Plated Cable SPC (2 pin-0,78, 2,5 mm, Moss) - 9.2mm ID 4.4mm cable hole and 11mm deep.

Simple, quick print - slot into place, holds well enough for my needs, job done 👌

Aria and Salnotes pic show quick n dirty prints (sure you can do much better):  0.6mm nozzle, 0.3mm layer height, PETG 

2nd pic of Tripowin cable at 0.2mm layer height and standard 0.4mm nozzle. 100% infill

PLA and other filaments should work fine. 

Maybe wasted my time uploading this as its a very specific thing but if not - do like n all that “sharing is caring” goodness 😉