Stackable Moss Pole, Easy Install, Removeable, No Supports! WIP

Printing:

Print 1x main body and left/right side.

Print 2x side clip for each additional layer. 

Print 4x strap per layer (works for me)

• No supports.
• .2mm layer height
• Quality defaults

How to use

1. Determine how many levels you will need by measuring the height of the selected plant. each level increases the height by 3.5 inches.
2. assemble the first level by pressing the side supports into their respective cut outs. Glue in position for increased stability. 
3. Add glue and press additional support add-ons onto the main body. 
4. Press side supports into position and add side clips to outside.
5. Place the empty moss pole in the desired position in the pot with the desired plant. 
6. Wrap the plant in moistened sphagnum moss and press into position on moss pole, starting from the top. after each leaf or section press on 1x straps across the open face so the leaf is resting on the strap. 
7. Continue until plant is fully supported. 
8. Mist the moss with dechlorinated water regularly.