Durafly Tundra Pan and Tilt

Not quite a remix but the tray is based on work done by Rob Thomson. https://www.thingiverse.com/thing:1362079

Use SG90 servo for the tilt.

There are two options for the pan servo (SG90 or TGY180).

Print Settings

Printer Brand:

Prusa

Printer: 

I3 MK3S

Rafts:

No

Supports: 

Yes

Resolution:

0.2

Infill: 

15

Filament: PETG 
 

Notes:

It's a bit over engineered.
I did print it with a standard 0.2mm print profile on my Prusa MK3s so it is heavier than it could be. (I needed to add 30g of lead to the tail to balance the plane afterwards!) I might print the next one using 1 perimeter (wall) thickness.

N.B. The fix for this was to cut some foam away inside the fus' so that the battery can move back further.

The tray has two pegs on left and right hand edges. Print the part on its side. The pegs will make the part level when it prints.

Category: R/C Vehicles