Duct Booster with F3D (so you can easily customize to fit your duct)

Duct Booster with F3D (so you can easily customize to fit your duct)

Works with 420CFM 8 inch Inline Grow Fan:

https://www.amazon.com/gp/product/B09PDMR12B/ref=as_li_tl?ie=UTF8&camp=1789&creative=9325&creativeASIN=B09PDMR12B&linkCode=as2&tag=voiyt-20&linkId=c25aef72a94e9542ff1a4ca300dc2054

The Duct Booster 1 & 2 prints in Vase Mode with 0.4mm bottom at 0.2 resolution.

Prints within 2.5 hours each.

And the cover prints normally without any supports and takes about 4 hours.

9 hours total print time.

No hardware necessary for install.

Just slots into the duct very easily and then held together by the fan itself.

Works great for HVAC in old homes where the upstairs is always 6 degrees off the main floor.

There are some duct boosters in the market that costs over 65 bucks, but has very low power - only about 70 CFM.

This is great because:

1 - Control from the room
2 - Low noise and low power (45W)
3 - 420 CFM!!!
4 - Suction is more efficient in old houses, since boosting from basement is less effective
5 - Easy 1 minute installation
6 - No screws / hardware required - just slots into the vent
7 - Fan is a 8” Grow Fan
8 - Literally blows the competition away - LOL
9 - When you move, just take it with you

The model is available for free download and use.

If you still want to invite me for a coffee for my effort, troubles and time, you can do it via:

https://www.paypal.com/paypalme/avicode

Thanks!