Parameterized offset jig – Filament sensor adaptor for BMG on CR6SE

You have a part mounted on your thing at position A, and you need it to be in position B, using the original screw holes at A. This is what you need. This will create an adaptor or jig that mounts to the part's original location and provides the same screw holes for the new location.

The example STL and pictures provided are to relocate the filament sensor on a Creality CR6SE when the stock extruder has been replaced with a BMG Dual-gear extruder.

It repositions the sensor so the output is properly located, and additionally set back in the X direction to get better access to the filament between the two. The given holes in the “offset plate” are right-sized for M3 screws to self-tap. “Access holes” allow access to the original screw locations.

The SCAD file is extensibly customizable for other uses, with the following restrictions.

• The “plate” that the part resides on must be roughly rectangular in area.
• The offset cannot go outside the bounds of the original location, or the “joiner” will not appear. I.e., don't go too far!
• Screw holes in the original and offset locations cannot overlap.
• OpenSCADs customizer does not support customizing lists of lists, so that entry will need to be modified manually.

I hope this is useful to folk!