Cardinal

Yes

High

If you want it to be three colors, use the first color until around 78%, then switch to second color. For the third color switch the filament at 96%. Also, it is better to switch later rather than earlier because an extra layer can hide underneath the rest of the colors while a layer on top of the lower tier sticks out (if switched too early). The "halo" at the top of the cardinal is to keep it stuck to the bed. It can be removed easily once the print is finished. For the legs, I used thin black twine. Put both ends through the back to the front, and put knots in both legs right in front of the holes. Then put knots in both legs for the knees. This takes about 30 minutes to print.

For the legs, I used thin black twine. Put both ends through the back to the front, and put knots in both legs right in front of the holes. Then put knots in both legs for the knees.