Asetek Front Mount Button Cover

Are you tired of seeing the exposed wires on your 1000€+ Front mounted Asetek Wheelbase?

Me too. So heres a simple Print to cover them up. It is one piece and doesnt need any support.

I decided to give them a 90° corner, so that the cable can go neatly to the wheelbase. But i added a straight version aswell, if that what you like more.

The left side is tested, but the right one is not. But since they're the same buttons, there shouldn't be any problems.

.step files are included for easy remixing.

Have Fun!

Mounting

First you have to click in the part for the buttons. It's a little snap fit.
The cables go through the Channel at the bottom. Then push the rubber cable relief in the slot, until it clicks. Thats it.

Printing recommendation

A Raft could be good for printing, because the tolerances for the back rubber are quite tight. I printed it without a raft and had to remove some material with a knife. I added a little chamfer afterwards, but havent tested it yet.