Prusa XL series: 5x Filament Sensor left

I wanted to have all Filament Sensors on one Side. So i made a part that combined the 2 Sensors and added the Numbers via Prusa Slicer.

You will most likely also be changing the PTFE tubes of the 3 Extruder on the right to be longer. Also the Cables from the Right Filament sensor (4 , 5 , and :) ) would need to be extended.

This Filament is very tolerance sensible. Please print as fine as possible, and have your settings dialed in. Even Wet Filament will ruin your toleranze to the point you can not use it.

Depending on where exactly you want you filaments to be, you maybe need to use the Adapter 90° Adapter.If so, 2 Square nuts , is all you need.

For everyone planning to Position the Sensor left or right, you will need to change the longest PTFE Tube for a longer one. Make Sure to get a PTFE Tube mit 4mm Outer Dimension, and (important) 2,5 mm internal diameter.

Also check this out:
https://www.printables.com/model/443298-prusa-xl-series-xl-front-frame-with-spool-holder

It is a Mount for the spool holder, in the Original Design of the XL

After many asked me how they could support me, you can now 

Tip me on KO-FI by klicking here:

                                                      https://ko-fi.com/surfalex2000

Check out my other optimized XL Parts! There is a Series to come!

You can find them in my Collection:
https://www.printables.com/@Surfalex2000/collections/830114