Multi D-Link DGS-108 switch holder

Multi D-Link DGS-108 switch holder.

We use several stacks of the named D-Link DGS-108 switches in some laboratories and they use to look messy when they are stacked on each other because the tend to slide around…

This little holder should keep them from sliding around. =)

The holder is available to secure 2, 3 and 4 switches in place.

You will need between 4 and 12 M5x20 screws to mount the holder depending on the amount of switches you want to hold in place.

Printing instructions:

• 0.3 draft profile.
• Textured sheet used for the outside parts to look nicer.
• Steel sheet used for the connector parts, because they are not really visible in the end.
• No brim needed
• No supports needed.

Happy printing =)