April 10, 2023
Description
Print in place. No supports required. I recommend PLA and 0.2 layer height.
Use 5x1mm magnets for the thin cover, 6x3mm for the thick Cover. Need another magnet size? Leave a comment.
Update: There is a latch version now. If it doesn't open, press a little bit against the spine.
The thick cover's spine sticks out a bit but I haven't found a better solution without giving up supportless angles, and stability.
Variation of my other dice book: [Print in Place] Dice Book
License:
Creative Commons — Attribution — Noncommercial
Digitale Lehrerin
