Picture Hanger (Sawtooth)

I like to do my own framing of printed photos, but the frames often lack a good mounting point. This 3D printed part adheres to the back of the frame. For lighter frames, I've been using high strength 3M mounting tape (3M Scotch Extreme Mounting Tape, 1 inch wide). For heavier frames I suggest glue, such as cyanoacrylate or hot melt (my favorite!).

For the wall I use WallDriller drywall anchors, although about anything will work.

Nothing special about printing this, 50% fill, .15 to .2 mm layer, support enabled.

Enjoy!

Category: 2D Art