ENDER 6 Pro - Filament Run-Out Sensor Offset Block for use with EIBOS Dryer

EIBOS cannot sit directly under standard filament sensor mount on the side of the case of an Ender 6.  The Power Cable is in the way.

This block offsets the Filament Run-Out Sensor to basically max (stock) cable length, and also mounts the Red Filament Guide supplied by Micro-Swiss with the NG Direct Drive Extruder upgrade for the Ender 6.

This allows you to still use the Filament Run-Out Sensor with the EIBOS Cyclopes Drying Unit.

M3 Nuts and M3 screws (other that what comes with Ender 6) will be needed to mount this offset block.

NOTE:  I only have Rev00 installed on my ENDER 6 so that is why the pictures showing my ENDER 6 do not have the additional side holes (in the offset bracket, added in Rev01) to utilize less material and give the sensor cable and easier path back to the main board.