April 5, 2023
Description
I have two Elegoo Neptune 2s side by side and needed to redirect the draft from the psu from one on the left away from the one on the right and back wasn't an option either so i made this one.
Prints easily with organic supports to hold up the screw holes, uses the original hardware, nothing extra is needed and can be pointed down too if you want to.
The duct may also fit similar psu's but i cannot test as i only have Neptune's but the holes measure 70mm center to center, top left to bottom right. let me know if you try and they fit!
I printed these in black Pla+ @0.2mm layer Height using organic supports in prusa slicer.
License:
Creative Commons — Attribution — Noncommercial — Share Alike
7
joshua Bentley
