Assemble after print - Cascade card wallet with levers on both side remix

UPDATE 2026/07/02: Consider this instead:

I find the original a bit tight/tough to dispense all cards in the stack, also there's not enough space to identify and  pick a card. My solution, dispense half the stack on one side. I have to model this from the ground up to apply my improvements/changes, taking the original look and design as reference. This model is about 4mm shorter than the original

Thanks to the original designer and all the remixers.

Print in PETG for the best wear-resistance and flex.

Parts for 6 or 8 cards provided. Parts prints flat with no support needed.

For 6 cards: 1x body6, 2x button6, 2x fan3, 2x lever6-xxx
For 8 cards: 1x body8, 2x button8, 2x fan4, 2x lever8-xxx

Dry fit parts, sand/file if necessary before press fitting. Use c-clamp when pressing button and lever if necessary.

When using, fans can/will collide, use cards to push them to slide in place.

Enjoy!