3.5mm Locking Headphone Jack Holders & Clips

I wanted to run a headphone extension cable from my audio interface around the back and under my desk so it's out of the way of my arm. This particular extension cable has an indentation in the casing, so I designed a holder that takes advantage of that. It also has a small lip at the tip of the jack, and the holder design uses that to help lock it into place. (That's not an affiliate link.) You probably will have to hold the case to the holder the first time you plug in the headphones but after that it should be locked in.

See the ZIP file for a little how-to MOV.

Also made complementary cable clips, two versions of those too.

Versions with and without screw holes. Diameter of holes is 6mm so use whatever screws you have, toss on a washer if needed. Otherwise use glue, two-sided tape, or Command strips.

Printed with Prusament Galaxy Black PLA (.20mm). If you use PLA, be careful with it, it can break - especially the cable clips. Use PETG for a bit more toughness.