ATEM Mini & Mini Pro mounts and 80mm fan adaptor

I noticed that my ATEM Mini would sometimes run a little warm, and I also wanted some means to mount it securely. I also have a Teredek Vidiu encoder that runs pretty warm, so I originally modelled up a Mount that held both units and also incorporated a 120mm quiet running fan.

I've since dropped that fan-mount as it was too big for my portable streaming rack that I built, and I have come up with a smaller fan mount for just the ATEM mini (not tested yet, and I will probably modify that for cooling the Vidiu)

So at the moment there are several STL's available, (these 1st ones I have not tested these versions) there are simple hold-down brackets for both LH and RH sides of the ATEM mini (and the ATEM Mini PRO as they both share the same case), also a 80mm fan mount for either LH or RH (depending on where you may have the space for the fan), also a Mk1 hold-down bracket (this is tried and tested) but you will have to "Mirror" it in your slicer to get the opposite bracket, and there's also a 120mm fan mount that also has a port for cooling a Teredek Vidiu (std Vidiu, but I think the Vidiu Pro has the same case, so it should fit too)

There is a fan in the ATEM mini's, but it never seems to run except when you do a firmware update (as I recall it exhausts out of the left (as you look from the front) of the unit

Also included in the files are the Fusion360 file that contains all of the above apart from the Mk1 hold-down bracket (somehow it got lost in the ether)

Print Settings

Printer Brand:

Anet

Printer:

Rafts:

Doesn't Matter

Supports:

Resolution:

0.2

Infill:

Notes:

Supports will most likely be needed for the Fan mounts, and depending on the orientation for printing of the hold-down brackets, you may or may not need supports here too.

Category: Camera