Logitech G Pro Wireless (x-superlight-wireless) mouse case - Rugged Box (Parametric)

Update [23.7.2025] added versions for 25mm and 20mm long screws. 
*Added at the request of @SamC_3382651, I haven't printed them personally, but they should work without problems.
  

Hello. I have a Logitech G Pro Wireless (x-superlight-wireless) mouse case here. This is a remix of “Rugged Box (Parametric)”. Easy to print. Durable but not waterproof. Perfect for traveling so that your precious mouse doesn't get damaged.

Component:
 

1. 6x M3 30mm screw.
    
2. Two neodymium magnets - Height - 3mm Diameter - 6mm (they are not needed, but the mouse then attaches itself to the right place and stays there)
    
3. Foam to keep the mouse in place - Made for foam from the original packaging which is then glued to the top cover. (if you no longer have the original box, you need foam about 5mm high)

Installation:

• Magnets- If you want to use magenta, you need to insert them into the cover during printing at a height of 3.60 mm using the print pause in the g-code. Pay attention to the correct polarity of the magnet!
• Foam - You simply peel off the foam from the original box and stick it to the top cover in the marked circle using adhesives.
• Then screw everything together and you're done.
• The seal does not need to be printed! But it is in the original version, so I decided to add it here as well. 

If you decide to print the box, I would be delighted to see your photos :D.